Bar Keepers Friend really works!

I had heard about oxalic acid and its power to remove rust from bicycle as well as many metal parts. In my research I also found out the active ingredient in Bar Keepers Friend is oxalic acid. It just so happens that I had just received a rather rusty Fuji Feather Professional Ishiwata BMX fork and have a bottle of Bar Keepers Friend under the kitchen sink.

So, here’s what I did. I got a large plastic bin I had purchased at Costco some time ago. I put one cup of Bar Keepers Friend in the bin and then filled it with hot water until the fork was completely covered. I carried the bin outside to let it sit for a few hours. Before walking away, I couldn’t help but pull the fork out to see if any thing was happening. Sure enough, with the wipe of my finger rust was already coming off! I was looking forward to the result!

3 hours later I began to lightly scrub away the rust with a Scotch Brite blue non-scratch sponge. Below are the results.

Classic Fuji Bicycle Fork Rust Removal Bar Keepers Friend

After and Before

Classic Fuji Fork Rust Removal with Bar Keepers Friend


Final Challenges on the 83 Fuji Cruiser

Spent a couple hours this morning on the 83 Fuji Cruiser. First challenge was the seat tube and chain guard decals. These were both removed from the bicycle at some point. I am trying to get the color as close as possible to the current decals, and this has proven to be a real pain and ink waister but, I’m very close now. I used Photoshop and Microsoft Word to create the decals and then manually cut them out with scissors.

1983 Fuji Cruiser Decals

I got the sticker paper from; quality stuff. I am finding the OL177WI weatherproof gloss white paper to work the best. The OL177CK (or clear back) seems ok too. Either way, do not touch the printed part with your fingers regardless how long you let it dry; otherwise you will leave finger prints.

The decals I got from Velocals, while a quality print job, were way off in regards to color and the spread between the two vertical “Fuji” texts on the seat-tube decal is too narrow. So, when you wrap them on the seat-tube you can never line them up on each side. Keep in mind I’m trying not strip the current surviving decals even though the frame has many chips and scratches. A survivor is only a survivor once, right? If I did strip them, then I would repaint the frame and likely use the Velocals after requesting a re-size for the seat-tube decal. Then all the decals would match, but not be their original color.

Chain-guard for 1983 Fuji Cruiser

Next, I got to work mounting the chain guard. I forgot I had yet to find a 40t chain wheel and the 44t on there made the chain guard a tad too small. Thankfully I had a 42t and I can make it work with a little tweaking of the mounting hardware. Once I find a 40t gold Sugino chain wheel it should be a perfect fit.